Memmert Central water supply - Manual (Page 14)

14
Replacing fi lter cartridges
3.5 Put the covers back on
1. Carefully push the side and rear cover (U-shaped profile) back on and tighten (Fig.
10). When doing so, make sure that no lines or tubes get squashed, bent or dam-
aged.
2. Put the cover back on and fasten with four screws (Fig. 11).
Fig. 10
Push the side and rear cover (U-shaped pro-
file) back on and screw tight
Fig. 11
Put the cover back on and fasten it
3. Connect the power supply unit to the mains supply and the 12-V connection at the
front to the central water supply.
4. Re-establish the water supply (open water tap).
5. Put humidity chambers back into operation. Check that there are no leaks in the
water supply. If water should leak out: Check the tube connections. If water is leaking
from the bottom of the central water supply: Undo covers again, look for the leak
and eliminate it.
3.6 Disposing of used fi lter cartridges
Used filter cartridges can be disposed of in normal household waste.