Mayline Light Box - Manual (Page 4)

DIMMING CONTROL
ON - OFF SWITCH
Remove these 3 screws
for lamp access
ADJUSTMENTS AND SERVICE FOR LIGHT TOP
1. WARNING - Always disconnect power before opening to avoid shock hazard.
For proper operation, unit must be plugged into a 3 wire grounded outlet.
2. Lights are operated by depressing push-button once to turn light on or once
to turn off. Sliding the dimmer control lever controls the brightness level.
3. To replace lamps:
A. Remove three 1/4-28 Round head matching screws close to front.
B. Lift wood top frame by edge and support with prop rod found in right
hand side of lamp compartment. Lift rear end of rod out of clip and
insert rod end into round hole in underside of top frame.
USE ONLY cool white rapid start lamps, either F25T8 (36" long) or
F32T8 (48" long).
DO NOT USE "Wattmizer" of other wattage lamps.
4. For best operation, replace all bulbs at same time.
5. Information on the electrical system shown for reference only
for service by qualified electrician.