beautypg.com

Mayline Light Box User Manual

Page 3

background image

INSTRUCTIONS FOR MOUNTING LIGHT BOX

ON POWER TABLE BASE

EXPANSION NUT (E1)

These 2 holes for mounting of Power Base
control switch box at final assembly.

1. With Light Box face down (still in carton or placed on clean, smooth

surface) insert Plastic Expansion Nuts (E1) in holes "A". Nuts may be tapped

lightly with a hammer to seat them.

2. Place top mounting brackets on the power base in near horizontal position.

3. Center Light Top over board brackets with pencil trough to front of base.

Align holes in the light top with the slots in the brackets.

4. Attach the light box with #10 x 3/4 Screws (E2).

NOTE: Screws should only be drawn up snug. DO NOT over tighten.

FOLLOW INSTRUCTIONS WITH BASE FOR CONTROL INSTALLATION