Mark Feldstein & Associates Flameless LED Wax Filled Mosaic Globes - Manual

I N S T R U C T I O N S
1. Install 3 “AAA” batteries (not included) into the
bottom battery compartment. Make sure that the
battery polarity (+/-) is as indicated. (see A)
2. Use the On-Off-6H Timer switch on the bottom
of the candle to turn LED to the OFF, ON or
6H (6 hour timer)* position. (see B)
3. If not set to 6H position, switch to OFF
position when not in use.
*Built-In Automatic Timer Function. When switch is
set to the 6H position, the LEDs will turn on for
6 hours and then automatically turn off for a period
of 18 hours. If the timer function settings are not
changed, the LEDs will automatically turn on and
off at the same time each day.
Warning: The Candle is made from real wax. It is recommended that the wax
candle be kept out of high heat environments and not placed directly on a porous
surface. Heat may cause the candle to change shape, melt or bleed onto
unprotected surfaces.
BATTERY NOTICE
Do not mix old and new batteries. Do not mix alkaline, standard (Carbon-Zinc), or
rechargeable (Nickel Cadmium) batteries. Replace all batteries at one time. To
avoid leakage or explosion, do not put batteries in fire. Remove batteries if
consumed or if product is to be left unused for a long period of time. Clean the
battery contacts and also those of the devices prior to battery installation.
(A) (B)
Maumee, Ohio 43537
•
www.markfeldstein.com
6hr Timer Candle
ON
6H
OFF
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment
and receiver. • Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected. • Consult the dealer or an experienced Radio TV technician for help.
Modifications not approved by the party responsible for compliance could void user’s authority
to operate this unit.