Mark Feldstein & Associates 1.5 Flameless LED Votive - Manual

Operating Instructions
1. Use the On - Off switch on bottom of candle
to turn LED to On Flicker position or OFF position. (see A)
2. Switch to “off” when not in use.
3. To replace the included button cell (CR2032) open bottom
battery compartment cover, install one CR2032 battery,
replace battery compartment cover. Make sure polarity (+)
faces out as indicated. (see B).
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
Class B digital devices, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.