Lenze ECSZS000X0B - Manual (Page 16)

Mounting supply module ECSxE
External brake resistor/mains connection
EDKCSZS000 DE/EN/FR 4.1
16

H2_Netzltg_ext_BWltg_EN-ECSCS000_ECSXE_Steuerrltg_Sysbusltg_BL_EN
External brake resistor/mains connection
The shield sheet for the mains cable is only required if the mains cable > 0.25 m.
Cable of the external brake resistor Mains cable
ecs089 ecs088
 Insert the M6 screws into the elongated
holes and attach the shield sheet.
 Insert the M6 screws into the elongated
holes and attach the shield sheet
 Put the wire clamp for the shield connection
onto the cable of the external brake resistor
and press it down.
Move it towards the supply module until the
wire clamp snaps into place.
 Put the wire clamp for the shield connection
onto the mains cable and press it down.
Move it towards the supply module until the
wire clamp snaps into place.
 Put a cable tie around the cable of the
external brake resistor.
Fasten the cable to the shield sheet.
 Put a cable tie around the mains cable.
Fasten the cable to the shield sheet.