Lenze TCF Series remote keypad - Manual

Lenze Americas • 630 Douglas Street • Uxbridge, MA 01569 • USA
Sales: (800) 217-9100 • Service: (508) 278-9100 • www.lenzeamericas.com
KL01D
13416351
3. MOUNTING THE REMOTE KEYPAD
The diagram below illustrates how to mount the remote keypad to
a panel. Use the template in Section 2 to mark the location of the
mounting holes on the panel.
2. TCF REMOTE KEYPAD TEMPLATE
NOTE: Verify dimensions on printed page before using as a template.
Hold this page against the panel where the remote keypad is to be
mounted, and use a center punch to mark the location of the three
holes. The dotted line is the outline of the remote keypad.
4. WIRING CONNECTIONS
NOTE 1: The supplied cable can be used for distances up to 8 feet in low-noise
environments. For distances up to 100 feet, or in high-noise environments, use
Belden 9842, Carol C4842, or equivalent (24 gage minimum) wire only.
TCF SERIES REMOTE KEYPAD INSTRUCTIONS
(Manual Number: KL01D)
The TCF Series Remote Keypad option (844-250) allows the TCF
Series drive to be programmed and controlled from up to one hundred
feet away. When properly mounted, the remote keypad is rated NEMA
4X.
In addition to the functions available on the front of the TCF drive, the
remote keypad has Start/Stop and Forward/Reverse functions.
NOTE: The Remote Keypad option will only work with TCF drives
that have parameter version “501” or higher. The parameter version
appears momentarily on the drive display when it is powered up, and
also appears on a small label on the drive’s heatsink.
1. PARTS LIST
The TCF Remote Keypad kit (844-250) includes the following parts:
(1) Remote Keypad (1) Gasket
(2) Self-tapping Mounting Screws (1) Instruction Sheet
(1) Eight foot cable
NOTE: The supplied cable can only be used for distances up to 8 feet in low-
noise environments. For distances up to 100 feet, or in high-noise environments,
use Belden 9842, Carol C4842, or equivalent (24 gage minimum) wire only.
WARNING!
If OEM mode is selected (using Parameter 48), and if the OEM Default setting
for Parameter 14 is “01”, the remote keypad will be disabled, and the
STOP
key WILL NOT work. Refer to the TCF Installation and Operation Manual for
information on OEM Default settings.
WARNING!
Improper wiring may result in damage to the Remote Keypad. Keep the
remote keypad cable away from power wiring.
The Belden and Carol cables specified consist of two twisted pairs. Make
sure one twisted pair is used for power and the other is used for serial
communications. Do not mix connections between twisted pairs.
NOTE 2: TB-11 can supply up to
50 mA of power, and the remote
keypad requires 40 mA. To drive
auxiliary relays using the open-
collector outputs, an external power
supply is required.
REMOTE KEYPAD
(BACK VIEW)
JUMPER
(See NOTE 2
in Section 5)
TXA
TXB
11
2
UP
TXA TXB 1 11 2 4
Cable included with kit
does not have a shield
TCF TERMINAL STRIP
PANEL
REMOTE
KEYPAD
GASKET
MOUNTING
SCREWS
1/8” hole
1/8” hole
1.57”
1.32”
1.38” to 1.5”
hole
3.38”
2.19”
UP
Max Depth = 0.72”