Lenze P94DLL01A - Manual (Page 5)

5 P94DLL01A
Operation
Systems including controllers must be equipped with additional monitoring and protection devices accord-
ing to the corresponding standards (e.g. technical equipment, regulations for prevention of accidents, etc.).
You are allowed to adapt the controller to your application as described in the standards documentation.
DANGER!
• After the controller has been disconnected from the supply voltage,
do not touch live components or power connection until capacitors can
discharge. Wait at least minutes before servicing the drive Please
observe the corresponding notes on the controller.
• Do not continuously cycle input power to the controller more than once
every three minutes.
• Please close all protective covers and doors during operation.
WARNING!
Network control permits automatic operation of the inverter drive. The
system design must incorporate adequate protection to prevent person-
nel from accessing moving equipment while power is applied to the
drive system.
Pictographs used in these instructions:
Pictograph Signal Word Meaning Consequence if Ignored
DANGER! Warning of Hazardous Electrical
Voltage. Reference to an imminent dan-
ger that may result in death or
serious personal injury if the
corresponding measures are
not taken.
WARNING! Impending or possible danger to
personnel Death or injury
STOP! Possible damage to equipment Damage to drive system or its
surroundings
NOTE Useful tip: If note is observed, it
will make using the drive easier
1. Reference Documents
• PositionServo Programming Manual: PM94P01
• PositionServo User Manual: S94P01C
• MotionView Software Manual: IM94MV01A
Refer to: http://www.actech.com