Lenze SS208AC - Manual (Page 10)

SimpleServo 100/200 User Manual Rev 3.4
Installation
WARNING!
Hazard of electrical shock! Circuit potentials are at 115 VAC or 230 VAC above earth
ground. Avoid direct contact with the printed circuit board or with circuit elements to
prevent the risk of serious injury or fatality. Disconnect incoming power and wait 60
seconds before servicing drive. Capacitors retain charge after power is removed.
• The SimpleServo must be mounted vertically for safe operation at the maximum
current rating.
• Printed circuit board components are sensitive to electrostatic fields. Avoid contact
with the printed circuit board directly. Hold the SimpleServo by the case only.
• Protect the control from dirt, filings, airborne particles, moisture, and accidental
contact. Provide sufficient room for access to the terminal block.
• Mount the control away from other heat sources. Operate within the specified
ambient operating temperature range. Additional cooling with an external fan may be
recommended in certain applications.
• Avoid excessive vibration to prevent intermittent connections.
• DO NOT connect incoming power to the output motor terminals (U, V, W)! Severe
damage to the SimpleServo will result.
• Do not disconnect any of the motor leads from the SimpleServo unless power is
removed or the control is disabled. Opening any one motor lead may cause failure.
10