7 process data transfer, Process data transfer, Process data transfer 7 – Lenze E82ZAFIC010 User Manual
Page 33: 7process data transfer
Process data transfer
7
l
33
EDS82ZAFIC EN 2.0
7
Process data transfer
INTERBUS transmits two different data types between the host (master) and the
controllers (slaves):
ƒ
Parameter data
ƒ
Process data
Process data
ƒ
Process data is transmitted via the process data channel.
ƒ
The process data serves to control the controller.
ƒ
The host can directly access the process data. Data in the PLC, for instance, are
directly stored in the I/O area.
ƒ
The data exchange between the master drive and the controller is required in the
shortest possible time. Here, small amounts of data can be transmitted cyclically.
ƒ
Process data ...
– are not saved in the controller;
– are transmitted between the host system and the controllers in order that a
constant exchange between current input and output data takes place.
ƒ
Process data are, for instance, setpoints and actual values.
Parameter data
ƒ
Parameter data is transmitted via the parameter data channel (PCP channel).
ƒ
The transmission of parameter data is usually not time−critical.
ƒ
Parameter data are, for instance, operating parameters, motor data and diagnostic
information.
ƒ
The access to all Lenze codes and indices is permitted.
ƒ
When saving parameter changes, please observe the notes regarding code C0003.