Labnet Deluxe ProBlot Hybridization Systems (6, 12, 12S and 24) - Manual (Page 8)

TROUBLESHOOTING GUIDE (continued)
PROBLEM POSSIBLE SOLUTION
Temperature is too low If door has opened, unit may not have recovered yet.
Confirm temperature set point.
Unit will not heat above temperature Confirm set point. Check temperature of chamber
that is below set point with a thermometer and recalibrate if needed.
Temperature display and reference Be sure that unit has been allowed to stabilize for
thermometer do not match 1 hour. Thermometer should be suspended in
rotating bottle and not touching bottle surface. Only
certified reference thermometers should be used.
Can not adjust set point or calibration Turn unit off for 5 seconds to reset. If problem
persists call service
Unit calibrated at one temperature This can be a normal condition if temperatures or
load not at another vary widely. For best accuracy, calibrate at set point
TECHNICAL SUPPORT / SERVICE
Should your ProBlot hybridization oven require service, call Labnet International’s Service Depart-
ment at 732-417-0700 between the hours of 9:00am and 5:00pm EST. If service necessitates the
return of the unit to Labnet’s Service Department, a return authorization (RA) number must first be
obtained and a decontamination certificate completed. The unit must be thoroughly decontami-
nated before shipping. The unit must then be sufficiently packed for shipment. Any shipping dam-
age on returned units will be the customer’s responsibility.
ACCESSORIES
B3003 Large 300x35mm bottle w/cap B1500-CAP Cap for 35mm bottles
B3003-PC as above with safety coating B2500-SEAL Seal for all 35mm bottles
B3003-DC Large bottle with caps on both ends B1124 Rack for 6 35mm bottles
B2503 Medium 250x35mm bottle H9088 Mesh 23x23cm (pack of 5)
B1503 Small 150x35mm bottle w/cap H9089 Mesh 10x15cm (pack of 5)
B1503-PC as above with safety coating B0753 Small 75x35mm bottle
B2753 Small bottle with 2 x75mm chambers B1507 150x70mm bottle, vented
H1200-RA Rocking platform B3007 300x70mm bottle, vented
H1200-250A Clamp platform 6 x 250ml flasks H1204-80A Rotisserie 4 x 70mm bottles
H1212-40VA Rotisserie 12 x 50ml tubes, vertical