Kuryakyn 1460 SNAP-N-GO DRINK HOLDER - Manual (Page 2)

PAGE
2
Ensure that the installation of this product does not interfere with the
proper operation of the motorcycle before riding.
Avoid damage to the motorcycle. Protect painted surfaces
with a soft cloth or blanket.
It is the installer’s responsibility to ensure that there is
adequate clearance between the Snap-N-Go Holder and any
painted surfaces. Küryakyn is not responsible for any damage
due to inadequate clearance.
Be aware of any cables/wires that could potentially be
pinched or crushed while using this product.
STEP 2 Place a clean, soft blanket over the gas tank to protect the paint.
NOTE: The Snap-N-Go Drink Holder has two different mounting options.
MOUNT
OPTION 1: Use the 1” clamp on the handle bar
STEP 3 Attach the Drink Holder 1” clamp to the handle bar with the two screws
and nuts provided in the kit. PIC 1
STEP 4 Install the 1/4-20 x 2-1/4" hex head cap screw, 1” sleeve, and a wave
washer through the clamp. PIC 1
STEP 5
Use another wave washer and the acorn nut to secure the bolt to the
clamp. PIC 1
STEP 6
Slide the Snap-N-Go Holder over the bolt and sleeve. Line up the head of the bolt with the cut out
on the bottom side of the drink holder, and snap it into place.
STEP 7
Turn the handlebars in both directions to their full stop position and ensure that there is clearance
between the Snap-N-Go Holder and the gas tank, dash and other accessories.
ENSURE THAT THERE IS CLEARANCE AT ALL POINTS WHEN THE
HANDLEBARS ARE TURNED, INSUFFICIENT CLEARANCE MAY CAUSE
DAMAGE TO THE MOTORCYCLE OR CAN CAUSE LOSS OF CONTROL THAT
COULD RESULT IN SEVERE INJURY OR DEATH.
STEP 8 Tighten all hardware.
TO PREVENT POSSIBLE LOSS OF CONTROL, WHICH COULD RESULT IN A
POSSIBLE INJURY OR DEATH, WE DO NOT RECOMMEND REMOVING AND
REPLACING OBJECTS IN THE HOLDER WHILE RIDING THE MOTORCYCLE.
Do not overload the Snap-N-Go Ring/Beverage Carrier with excessive weight.
Ensure that the Snap-N-Go Ring is secure on the Mount and that the Mount is
secure on the motorcycle. Küryakyn is not responsible for any belongings that are
stolen or damaged from use of this Drink Holder or from the Snap-N-Go Ring or
Mount not being properly secured to the motorcycle. It is the installer’s
responsibility to ensure that all of the fasteners (including pre-assembled) are
tightened before operation of the motorcycle. Küryakyn will not provide warranty
coverage on products or components lost due to improper installation or lack of
maintenance. Periodic inspection and maintenance are required on all fasteners.
SNAP-N-GO DRINK HOLDER
INSTALLATION
-cont.-
PIC 1
PIC 2
WAVE WASHERS
ACORN NUT
1” SLEEVE
2-1/4” HEX HEAD
CAP SCREW
1” CLAMP
2-1/2” HEX HEAD
CAP SCREW
1” SLEEVE
SPACERS