beautypg.com

Kuryakyn 557 CLEAN CHROME HEAT SHIELD FOR POWER CELL User Manual

Kuryakyn For motorcycles

background image

THANK YOU FOR CHOOSING CRUSHER! 

PROTECT YOURSELF AND OTHERS FROM POTENTIAL INJURY AND PROPERTY DAMAGE OR LOSS. PAY CLOSE ATTENTION TO ALL 
INSTRUCTIONS, WARNINGS, CAUTIONS, AND NOTICES REGARDING THE INSTALLATION, USE, AND CARE OF THIS PRODUCT. 

C L E A N   C H R O M E   H E A T   S H I E L D   F O R   P O W E R   C E L L  

557

 

THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED 
HEREIN CAN RESULT IN POTENTIAL DEATH OR SERIOUS INJURY. 

This indication alerts you to the fact that ignoring the contents described herein may 
negatively affect product performance and functionality or damage the product itself or 
the product to which it is being attached. 

ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:

 

 

Clean Chrome Heat Shield for Power Cell 

 

Installation Instructions 

SUGGESTED TOOLS: 
Nut drivers, flat blade screwdriver 

 

 

 

STEP 1 

Read and understand all 

STEPS

 in the instructions before starting the installation. Park the motorcycle on a hard, 

level surface and turn off the ignition. Allow the engine and exhaust system to cool. 

 

 

STEP 2

 

Loosen the clamps and remove the existing heat shield from the exhaust system. 

STEP 3

 

Remove the clamps from the existing heat shield; set the heat shield aside, it will not be reused. 

STEP 4

 

Install the clamps as shown in PIC 1. Ensure that the clamp fasteners are accessible when installed, if not remove 
them and flip them around. 

STEP 5

 

Position the new Heat Shield over the exhaust system; connect the clamps and begin to tighten them. 

STEP 6

 

Ensure that the Heat Shield does not contact the surrounding heat shields, then tighten the clamps; tighten any 
remaining clamps. 

557‐11CR‐0814 

These installation instructions contain important information. Ensure that the end user 
receives this copy and is aware of its importance for future use. 

INSTALLATION REQUIRES CONTACT WITH THE EXHAUST SYSTEM. ENSURE THAT THE 
EXHAUST SYSTEM HAS FULLY COOLED BEFORE BEGINNING TO PREVENT INJURY.