Kuryakyn 3990 BLACK ERGO III ADJUSTABLE CRUISE MNTS w/ TRIDENT DUALLY PEGS - Manual (Page 3)

PAGE
3
STEP 7
Refer to PIC 8. Position the clutch-side upper clamp-half
(separated in
STEP 3
) over the engine guard and align it
with the bottom clamp-half. Secure the bottom to the top
with the four screws removed in
STEP 3 . PIC 8
NOTE: Do not fully tighten the screws at this time.
Leave them snug to allow for adjustment of the
mounts.
STEP 8 Repeat STEPS 2 through 7 for the brake-side (right).
EXTENSION ARM AND CLEVIS INSTALLATION:
STEP 9
Locate one of the Extension Arms in the Hardware Kit. The Arms are NOT side specific.
STEP 10 Refer to PIC 9 below. The Extension Arms allow for three possible positions. A shows a possible
Extension Arm position for riders with shorter legs. B shows the position for riders with medium
length legs. C shows the position for riders with longer legs. Determine which Extension Arm posi-
tion will suit you best.
STEP 11
On the clutch-side of the bike, attach the Extension Arm to the Rotating Arm with two of the in-
cluded 1/4”-20 X 1-1/8” Button Socket Head Screws. Thread the screws through the Extension
Arm and secure them on the back side with two of the included Nylock Nuts. Fill any exposed
threaded holes with the included 1/4”-20 X 5/16” Button Socket Head Screws. PIC 9
A
BLACK ERGO III ADJUSTABLE CRUISE MNTS w/ TRIDENT DUALLY PEGS INSTALLATION
PIC 6 PIC 7
PIC 8
UPPER CLAMP-HALF AND
ARM ASSEMBLY
SECURE THE BOTTOM
CLAMP TO THE TOP WITH
THE FOUR SCREWS
-cont.-
SHORTER LEG POSITION
MEDIUM LEG POSITION LONGER LEG POSITION
PIC 9
A
B
C
1/4-20 X 1-
1/8 SCREWS
1/4-20 X 5/16
SCREWS
CLUTCH-SIDE (LEFT) EACH POSITION IS APPROXI-
MATELY 1/2” APART
PIC 9 PIC 9