Kuryakyn 9432 HONDA HYPERCHARGER KIT - Manual (Page 4)

INSTALLATION
STEP 21 Loosely fasten the Hypercharger mounting bracket to the rear cylinder. The chamfered end
of the 1” spacer goes against the cylinder. Be sure to apply anti-seize compound to the fastener threads
before installing in the cylinder. See PIC.12 for proper assembly sequence.
STEP 22 Loosely fasten the Hypercharger mounting bracket to the front cylinder. The
chamfered end of the 1” spacer goes against the cylinder. Place the idle adjustment bracket
between the Hypercharger mounting bracket and the 1” spacer. Be sure to apply anti-seize
compound to the fastener threads before installing in the cylinder. See PIC.13 for proper
assembly sequence.
STEP 23 Install the idle adjustment knob in the bracket.
STEP 24 Position the Hypercharger assembly over the carburetor and secure the hose clamp.
See PIC.14.
STEP 25 Verify the manifold aligns with the carburetor and is not twisted; rotate the manifold
for proper fit, if necessary. Tighten the two mounting bracket fasteners to
secure the backing plate and mounting bracket. The top mounting leg with
rubber bump stop will be positioned behind your gas tank.
STEP 26 Connect the breather hose from top of the rear cylinder to the hose
barb on the new manifold. See PIC.15.
STEP 27 Adjust the Hypercharger position and tighten the mounting bolts.
STEP 28 Reinstall the round cover on the Hypercharger; fasten with four
screws.
STEP 29 Install the float bowl breather line onto the hose barb on the back of
the Hypercharger using the new hose.
STEP 30 Reinstall the seat, fuel tank, and dash panel; refer to your factory
service manual for specific information on this procedure. The top leg of the
Hypercharger mounting bracket rests against the gas tank.
STEP 31 Verify that all fasteners are secure and have Locktite applied, that all hoses are
connected and free from kinks, and that the throttle cables operate freely.
ATTENTION! It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will not issue
a warranty on components lost due to improper installation. Periodic maintenance may be
required.
PIC.11
PIC.12
RUBBER BUMPER
LOCATION
90° hOSE BARB
LOCATION
DOUBLE-ENDED
hOSE BARB
LOCATION
PIC.13
PIC.14 PIC.15
PAGE
4
hYPERChARGER