Kuryakyn 9529 ALLEY CAT for BOLT - Manual (Page 3)

PAGE
3
STEP 10
Refer to PIC 6. Thread the included 1/2” Elbow Hose Fitting into the included Air Cleaner Adapter.
Ensure the Fitting points inward when installed.
STEP 11 Refer to PIC 6. Install the included Rubber Inlet Flow Plate in
the Adapter as shown.
STEP 12 Hold the Adapter assembly up to the throttle body; attach
the breather hose to the Elbow Fitting and secure it with the
hose clip.
STEP 13 Position the Adapter so that the Rubber
Plate interlocks with the flange on the throt-
tle body.
STEP 14 Refer to PIC 7. Secure the Adapter to the
throttle body with the three OEM screws
removed in
STEP 2 . Leave the screws
loose until all three have been started, then
tighten.
STEP 15 Refer to PIC 8. Locate the Backing Plate in the kit. Install the included black
rubber Vacuum Caps over the nipples on the Backing Plate. Attach the Cap
Retainer Plate with the supplied #8-32 Button Socket Cap Screw and #8 Flat
Washer. Tighten securely. The dropped center of the Cap Retainer Plate goes
towards the Backing Plate.
NOTE:
Some parts are shown being assembled off the bike for
clarity; assemble parts on the bike by following the STEPS
below.
STEP 16 Refer to PIC 9. Insert the three included 1/4-20 x 1/2” Socket Head Cap
Screws through the mounting holes from the front of
the Backing Plate.
Place the Air Lock Ring (shown in PIC 8) over these
from the back side. The Air Lock Ring will act as a
gasket between the Backing Plate and the Air Filter
Adapter, no extra gasket will be needed.
Attach the Backing Plate assembly to the Air Filter
Adapter with the three Screws; tighten the Screws
securely.
ALLEY CAT for BOLT INSTALLATION
-cont.-
PIC 6
ELBOW
FITTING
POINTS
INWARD
INSTALL RUBBER INLET FLOW PLATE
IN BACKSIDE OF ADAPTER. ENSURE
PLATE FULLY SEATS IN RECESS
PIC 9
BACK PLATE INSTALLED
ATTACH THE
BREATHER
HOSE TO THE
FITTING
SECURE
THE
ADAPTER
TO THE
THROTTLE
BODY WITH
THE THREE
OEM
SCREWS
PIC 7
PIC 8
CAP RETAINER PLATE
VACUUM CAPS
BACKSIDE OF BACKING PLATE
AIR
LOCK
RING