Kuryakyn 2203 UNIVERSAL WIRING & RELAY KIT, PERCH MOUNT - Manual (Page 4)

PAGE
4
STEP 10
Refer to PIC 8 on
PAGE 3
. Route the wires (
4
and
5
) to the front of the bike. Secure all wiring
out of harms way with the included cable ties.
NOTE: The bullet connectors on the black and white wires are not intended to con-
nect with any Kuryakyn driving light kit; the connectors may be removed or
retained as necessary. It is up to the installer to determine the best connec-
tion for the installation.
STEP 11 Refer to PIC 8 on PAGE 3 . Route the Switch-Mount-Half wires to the Relay Harness. Connect
the two wires from the Switch to either of the two yellow wires from the Relay Harness. Make
sure the wires are fully seated in the connectors and the insulating sleeve covers the metal con-
nectors. Use the supplied cable ties to attach the wires to the bars and away from pinch points.
STEP 12
Connect the white wires from the Relay Harness to the driving light power wire (sold and installed
separately); use the supplied Male Bullet Connectors with Insulating Sleeves and the black wires
from the Relay Harness for driving-light ground-wires if necessary. If these ground wires are not
needed, they may be secured out of the way with cable ties.
STEP 13 Follow the driving light instructions to complete installation.
Reinstall the seat
STEP 14 Ensure ALL lighting and controls function properly BEFORE operating the motorcycle.
UNIVERSAL WIRING & RELAY KIT, PERCH MOUNT
Ride On!
INSTALLATION
Secure all wiring away from any moving parts, pinch points or extreme
heat. Kuryakyn WILL NOT provide warranty coverage on any electrical com-
ponent that fails due to pinched, crimped, broken, abraded, melted or
frayed wires.
It is the end user’s responsibility to ensure that all of the fasteners
(including pre-assembled) are tightened before operation of the motorcy-
cle. Küryakyn will not provide warranty coverage on products or compo-
nents lost or damaged due to improper installation or lack of maintenance.
Periodic inspection and maintenance are required on all fasteners.
THE END USER’S SAFETY DEPENDS UPON PROPER INSTALLATION
OF THIS PRODUCT. IF A STEP IN THIS SET OF INSTRUCTIONS IS
NOT WITHIN YOUR CAPABILITIES OR YOU DO NOT HAVE THE
CORRECT TOOLS, HAVE YOUR DEALER PERFORM THE PROCEDURE.
IMPROPER INSTALLATION OF THIS PRODUCT COULD RESULT IN
DEATH OR SERIOUS INJURY.