Universal wiring & relay kit, perch mount – Kuryakyn 2203 UNIVERSAL WIRING & RELAY KIT, PERCH MOUNT User Manual
Page 3
PAGE
3
CONNECT WIRING:
STEP 5
Use a test light and the model-specific wiring schematic to locate a “keyed” 12 volt accessory
wire (“keyed” power); this wire should have 12 volts with the IGN ON and no power with IGN
OFF to prevent draining the battery.
STEP 6
Once the “keyed” power wire has been located, turn IGN OFF, remove the seat, and disconnect
both battery cables.
Refer to PIC 7.
Clamp the included Female T-Tap Connector over the “keyed” power wire and
“snap” it shut; ensure that the tabs are engaged.
STEP 7
Refer to PIC 8. Locate the included Relay Harness.
Refer to PIC 8 and 9. Insert the exposed end of the YELLOW wire (
1
) into the included
Insulated Male Spade Connector; crimp the end making sure that the wire is secure.
NOTE:
Lay out, measure, and cut wiring before installing for the cleanest, easiest
installation. Add in a little slack before cutting the wiring.
STEP 8
Refer
to
PIC 9. Connect the YELLOW wire from the Relay Harness to the Female T-Tap on the
“keyed” power wire (from
STEP 5
).
STEP 9
Reconnect the positive battery cable along with the RED wire
(
2
)
from the Relay Harness to the
positive (+) side of the battery.
Reconnect the negative battery cable along with the BLACK wire
(
3
)
from the Relay Harness to
the negative (—) side of the battery.
UNIVERSAL WIRING & RELAY KIT, PERCH MOUNT
INSTALLATION
IT IS THE INSTALLER’S RESPONSIBILITY TO ENSURE THAT THE
INSTALLATION OF THIS ACCESSORY DOES NOT EXCEED THE
MAXIMUM AMPERAGE OF THE CHOSEN CIRCUIT. EXCEEDING THE
MAXIMUM ALLOWABLE AMPERAGE MAY LEAD TO CIRCUIT FAIL-
URE WHICH COULD LEAD TO COMPONENT FAILURE RESULTING IN
SERIOUS INJURY OR DEATH.
Dielectric grease inhibits moisture and prevents corrosion. Kuryakyn recom-
mends the use of the included dielectric grease on ALL electrical connections.
Apply dielectric grease directly to mating surfaces.
PIC 7
PIC 9
-cont.-
RELAY
FUSE
CRIMP
CONNECT TO SWITCH
CONNECT TO LIGHT (1)
CONNECT TO LIGHT (2)
+
—
PIC 8
RELAY HARNESS
1
2
3
4
5
CONNECT TO
“KEYED” 12V