Kuryakyn 7273 L.E.D. SADDLEBAG EXTENSIONS - Manual (Page 5)

PAGE
5
STEP 28
Remove the seat and locate the H-D main wiring harness.
STEP 29
Turn the key “ON” and using a test light or the wiring diagram for your
bike, determine the left and right turn signal power, running light power
and a ground wire. Label each of these wires for their function or write the
color and function down. Turn the key “OFF” and disconnect the
battery.
Avoid potential electrical shock! Be sure to disconnect
the battery before starting this procedure.
STEP 30 Place one of the included female T-Tap connectors on turn signal power
wire from the LEFT turn signal located in Step 29. Place one of the
included female T-Tap connectors on turn signal power wire from the
RIGHT turn signal located in Step 29. Place two of the included female
T-Tap connectors on the RUNNING light power wire located in Step 29.
Place two of the included female T-Tap connectors on the GROUND wire
located in Step 29.
NOTE:
If there is a run-turn-brake controller installed, the female T-Taps
need to be installed upstream (in front) of the controller. The
installation order must be main harness from front of bike with
the female T-Taps installed, then the controller, finally the taillight
harness.
STEP 31
Place a small amount of dielectric grease on the female T-Tap connectors;
insert the insulated male spade connectors from the BLACK wires into the
female T-Tap connectors that were installed on the GROUND wire, insert
the insulated male spade connectors from the BLUE wires into the female
T-Tap connectors that were installed on the RUNNING light power wire,
the insulated male spade connector from the BROWN wire to the female
T-Tap on the RIGHT turn power wire and the insulated male spade
connector on the PURPLE wire to the female T-Tap on the LEFT turn
power wire in the taillight harness.
STEP 32 Place some of the included dielectric grease on each connector. Connect
the three pin connector on the wire harness from the LEFT Saddlebag
Extension to three pin connector on the 8-Pin, 6-Pin or Hardwired
Run-Turn wiring adapter with the PURPLE-BLACK-BLUE wires. PIC 16
Connect the three pin connector on the wire harness from the RIGHT
Saddlebag Extension to three pin connector on the 8-Pin, 6-Pin or
Hardwired wiring adapter with the BROWN-BLACK-BLUE wires. PIC 16
Reconnect the battery.
STEP 33
Turn the bike on and test that all lights function correctly.
ENSURE PROPER LIGHT OPERATION BEFORE RIDING THE
MOTORCYCLE. VISIBILITY IS A MAJOR CONCERN FOR
MOTORCYCLISTS. A LIGHT MALFUNCTION COULD RESULT IN
DEATH OR SERIOUS INJURY.
STEP 34
Place the warning stickers on the inside of the bags as shown in PIC 17 to serve as
a reminder to prevent the wires from being damaged when the saddlebags are
removed from the motorcycle.
NOTE: After completing the installation, you may have to adjust your mufflers to
center them in the rear cut-out of the Saddlebag Extensions.
STEP 35 Replace the seat.
AFTER INSTALLING THE SEAT, PULL UP ON IT TO ENSURE IT IS LOCKED
INTO PLACE. A LOOSE SEAT CAN SHIFT AND CAUSE LOSS OF CONTROL
RESULTING IN SERIOUS INJURY OR DEATH.
Ride On!
L.E.D. SADDLEBAG EXTENSIONS
INSTALLATION
BROWN-BLUE-
BLACK WIRES TO
RIGHT EXTENSION
PURPLE-BLUE-
BLACK WIRES TO
LEFT EXTENSION
WIRING ADAPTER
CONNECTED TO MAIN
HARNESS
PIC 16
PIC 15
CUT THESE 3-PIN
HARNESSES OFF
8-PIN ADAPTER
PIC 14
MAIN TAILLIGHT HARNESS
APPLY LABELS
PIC 17