Kuryakyn 7273 L.E.D. SADDLEBAG EXTENSIONS - Manual (Page 2)

PAGE
2
NOTE:
Pictures shown of Chrome parts. Installation of Black parts will be the same.
YOU WILL BE WORKING AROUND THE ENGINE
AND EXHAUST SYSTEM DURING INSTALLATION.
ENSURE THAT THE ENGINE AND EXHAUST
SYSTEM HAVE FULLY COOLED TO PREVENT
INJURY.
Assistance is recommended in the installation of this
product to ease the installation and prevent damage.
STEP 2 Remove the saddlebags from the motorcycle.
Avoid damage to the saddlebags. Protect painted
surfaces with a soft cloth or blanket.
STEP 3 Starting with the right saddlebag, place it upside down on a soft
cloth or blanket. Place the right side L.E.D. Saddlebag Extension
on the bottom of the bag. PIC 1
STEP 4
Holding the Extension tight against the sides and bottom of the
saddlebag, mark the three holes from the Extension (PIC 1) onto
the bottom of the saddlebag with a center punch. PIC 2 Remove
the Extension.
MEASURE TWICE – DRILL ONCE. Double check all
reference marks made on the saddlebag BEFORE
drilling. Kuryakyn will not be responsible for
incidental or consequential damages resulting from
this installation.
STEP 5 Using a 9/32” drill bit, carefully drill out the three holes marked in
Step 4 using light pressure, the bags will drill easily.
STEP 6 Thoroughly clean the bottom of the saddlebag, where the tape on the Extension
will contact the bottom, with the included alcohol pads. Dry completely.
Ensure the area of installation is free of grease, oil, dirt or other
debris including wax/polish products and bugs to ensure proper
adhesion. Küryakyn WILL NOT issue a warranty on any parts lost
due to improper installation.
The adhesive will not bond correctly if applied at temperatures less
than 50°F. Do not attempt this installation in temperatures less than
50°F.
STEP 7 Rub the backing on the tape to activate the adhesive. Peel the backing off and
carefully place the Extension on the bottom of the saddlebag, lining up the holes
in the tabs with the holes drilled in Step 5.
STEP 8 Holding the Extension tight against the side and bottom of the saddlebag, insert
one of the included 1/4”-20 X 1” button socket cap screws with a 1/4”washer
under the head, then a rubber washer (PIC 3), into the front hole in the saddlebag
and through the Extension. Place one of the included 1/4” flat washers over the
exposed threads, then thread on one of the included 1/4” nylock nuts. PIC 4 Leave
finger tight for now. Repeat this for the next hole.
STEP 9 Locate one of the stainless attach clips from the hardware kit. Insert one of the included
1/4”-20 X 1” button socket cap screws with a 1/4” washer under the head, then a rubber washer,
(PIC 3) into the rear hole in the saddlebag and through the Extension. Slide the “forked” end of
the attach clip between the rear tab on the Extension and the saddlebag. PIC 5 Place one of the
included 1/4” flat washers over the exposed threads, then thread on one of the included 1/4”
nylock nuts. Leave finger tight.
L.E.D. SADDLEBAG EXTENSIONS
INSTALLATION
-cont.-
PIC 1
PIC 4
PIC 3
PIC 2
MARK THESE THREE HOLES
USING CENTER PUNCH
1/4”-20 x 1” BUTTON CAP SCREW
FLAT WASHER
RUBBER WASHER
FLAT WASHER
1/4” NYLOCK NUT