Kuryakyn 1757 LIGHTED MIRROR STEM COVERS - Manual (Page 3)

PAGE
3
STEP 8
On ‘95 and earlier models and any model without 8-Pin main harness
AMP connectors: Cut the two pigtails with the three pin connectors from the
supplied wiring adapter as close to the connection point as possible. PIC 9 The
remaining 8-Pin Connectors and harness will not be used. Continue to Step 8.
STEP 8
Using wire strippers remove a small amount of insulation from the cut ends of
the wires. Insert the exposed end of each wire into an included insulated male
spade connector and crimp the end. Make sure that the wire is secure in the
spade.
STEP 9 Remove the seat and locate the H-D main wiring harness.
STEP 10
Turn the key “ON” and using a test light or the wiring diagram for
your bike, determine the left and right turn signal power, running light
power and a ground wire. Label each of these wires for their function
or write the color and function down. Turn the key “OFF” and
disconnect the battery.
Avoid potential electrical shock! Be sure to
disconnect the battery before starting this
procedure.
STEP 11 Place one of the included female T-Tap connectors on turn signal power wire
from the LEFT turn signal located in Step 10. Place one of the included female
T-Tap connectors on turn signal power wire from the RIGHT turn signal located
in Step 10. Place two of the included female T-Tap connectors on the RUNNING
light power wire located in Step 10. Place two of the included female T-Tap
connectors on the GROUND wire located in Step 10.
NOTE:
If there is a run-turn-brake controller installed, the female T-Taps need to
be installed upstream (in front) of the controller. The installation order
must be main harness from front of bike with the female T-Taps installed,
then the controller, finally the taillight harness.
STEP 12 Place a small amount of dielectric grease on the female T-Tap connectors; insert the insulated
male spade connectors from the BLACK wires into the female T-Tap connectors that
were installed on the GROUND wire, insert the insulated male spade
connectors from the BLUE wires into the female T-Tap connectors that
were installed on the RUNNING light power wire, the insulated male
spade connector from the BROWN wire to the female T-Tap on the
RIGHT turn power wire and the insulated male spade connector on the
PURPLE wire to the female T-Tap on the LEFT turn power wire in the
taillight harness.
NOTE: It may be easier to raise or remove the fuel tank for the
next Step. Refer to the service manual for your model for
detailed instructions on removal of the fuel tank.
When raising the fuel tank, care MUST be taken not to stretch, puncture or break
the attached fuel line.
LIGHTED MIRROR STEM COVERS
INSTALLATION
PIC 8 WIRING HARNESS
WIRING HARNESS
COMES UP THROUGH
FRAME
CONNECTOR ON TRIKES HAS RED
WITH YELLOW STRIPE WIRE
BROWN-BLUE-
BLACK WIRES TO
RIGHT LIGHT
PURPLE-BLUE-
BLACK WIRES TO
LEFT LIGHT
WIRING ADAPTER
CONNECTED TO MAIN
HARNESS
PIC 7
MAKE SURE
WIRES ARE IN
CHANNEL
PIC 6
DO NOT OVER TIGHTEN
PIC 9
CUT THESE 3-PIN
HARNESSES OFF
8-PIN ADAPTER
PIC 10
-cont.-