Kuryakyn 1757 LIGHTED MIRROR STEM COVERS - Manual (Page 2)

PAGE
2
A FACTORY SERVICE MANUAL WILL BE HELPFUL IN PERFORMING THIS
INSTALLATION. DO NOT ATTEMPT TO PERFORM THIS
INSTALLATION IF YOU ARE NOT CONFIDENT IN YOUR
ABILITY TO COMPLETE ALL OF THE STEPS IN THE
PROCEDURE; CONSULT A TRAINED TECHNICIAN. IMPROPER
INSTALLATION COULD RESULT IN SERIOUS INJURY OR
DEATH.
The Mirror Stem Lights are intended for use as SUPPLEMENTAL turn
signals and running lights only. Any other use may be in
violation of Federal, State or local regulations.
STEP 2
Remove the three Phillips head fasteners from each Lighted Mirror Stem Cover.
Remove the two covers from each Stem Light. Remove each Stem Light. PIC 1
STEP 3
Determine the left from the right (sitting on the bike) chrome cover. PIC 2
Avoid damage to the motorcycle. Protect painted surfaces with a soft
cloth or blanket.
STEP 4 Remove the mirrors from the motorcycle as outlined in the service manual. Place
the chrome cover over the mirror stem. PIC 3 Place the Stem Light over the other
side of the mirror stem. PIC 4 Hold the Stem Light tightly into the cover and see if
these two pieces seem loose on the mirror stem. If the fit is loose or the assembly
seems to rattle, remove the cover and place a piece of the included foam tape on
the mirror stem as shown in PIC 5.
STEP 5
With the Chrome cover in place over the mirror stem, place the Stem Light onto
the cover. Place the top cover over the mirror stem, making sure the pin on the
top cover fits in the hole on the back cover. Fasten with one of the fasteners you
removed in Step 2. PIC 6 DO NOT over-tighten, just snug will do. Place the
bottom cover over the mirror stem. Make sure that the wires from the Mirror Stem
Light exit through the channel in the cover. PIC 7 Fasten with two of the fasteners
removed in Step 2. DO NOT over-tighten, just snug will do.
STEP 6 Repeat Step 4 and Step 5 for the remaining Mirror Stem Light.
Küryakyn recommends the use of dielectric grease on electrical
connections.
STEP 7 On ‘96 and later models with 8-Pin main harness Connectors: Remove the
seat and locate the H-D main wiring harness. PIC 8 (On trike models, locate the
8-pin connector from the main harness to the run-turn–brake controller. This is
the input side of the controller and the 8-pin connector will have a RED wire with
a YELLOW stripe. It should be located on the left side under the passenger
handrail.) PIC 8 Separate this connector, place some of the included dielectric
grease in each half, and plug the 8-Pin Run-Turn wiring adapter into each end.
PIC 8 Proceed to Step 13.
NOTE:
If there is a run-turn-brake controller installed, the wiring adapter needs
to be installed upstream (in front) of the controller. The installation order
MUST BE main harness from front of bike, then the 8-Pin wiring adapter,
then the controller, finally the taillight harness.
LIGHTED MIRROR STEM COVERS
INSTALLATION
-cont.-
PIC 1
PIC 2
PIC 3
PIC 4
PLACE CHROME COVER OVER STEM
PLACE LIGHT
OVER STEM
AND BACK
COVER
LEFT
SIDE RIGHT
SIDE
PIC 5
OPENING FOR STEM
PLACE TAPE
ON STEM
TOP COVER
AND FASTENER
BOTTOM COVER
AND FASTENERS
STEM LIGHT
CHROME
COVER