Kifco E30x660 400,000 - Present Operator Manual - Manual (Page 33)

P/N 19302460 Copyright © May 2013 by Kifco ® Inc.
Maintenance & Adjustments
Danger! All power sources including water pumps must be disconnected and secured
before performing any maintenance or adjustments on your water-Reel. Failure to dis-
connect all power sources before performing maintenance or adjustments may result in
machine damage, personal injury, or death.
Compensator Adjustment:
1. Remove the faceplate of turbine.
2. Remove the spring attached to the turbine compensation arm.
3. Place the compensation bar in the shut off position the bottom of the bar will contact the level-
wind frame.
4. Loosen the control wire by loosening the setscrew and the set collar where the control wire con-
nects to the turbine compensation arm.
5. Adjust the compensation spoiler to its fully compensated position it will be pointed directly to-
wards the center of the turbine.
6. Tighten the control wire by tightening the setscrew and set collar attach the spring and exercise
the compensation bar to verify the compensation spoiler functions properly with no compensa-
tion the compensation spoiler in line with the flow of water and with full compensation the spoil-
er should be 90 degrees out of line with the flow of water (pointing straight towards center of
turbine).
7. Replace the turbine cover and o-ring.
27