Kifco E30x660 400,000 - Present Operator Manual - Manual (Page 19)

P/N 19302460 Copyright © May 2013 by Kifco ® Inc.
Start Up & Operation
Step-by Step Operation Continued
2. Lower the stabilizer legs. Manually crank each leg into the ground until both stabilizer feet are firmly in-
serted into the ground.
Warning!
Never operate the Water-Reel with only one stabilizer leg in the
ground or without the stabilizer feet firmly inserted in the ground.
3. Lower the adjustable jack (see Tongue Jack instructions Page 25) and pull tractor around into position to
pull sprinkler cart down the irrigation lane.
4. Verify that the chassis of your Ag-Rain Water-Reel is level, if not adjust the jack accordingly. Also verify
that both stabilizer legs are securely in the ground.
5. Adjust sprinkler cart to the desired width. See “Specification” section.
6. Lower the sprinkler cart from its transport position. Set the desired sprinkler arc and confirm that the
sprinkler is equipped with the proper nozzle. Note: Turbine drive irrigators have a minimum G.P.M. flow
requirement. Do not attempt to operate at flows or pressures different from those listed on the
“Performance Guide” decal that is installed on the machine.
7. Lift Anti-Return pawl (Diagram below). If the pawl is under pressure, attach the PTO hand wheel to the
gearbox PTO shaft and rotate it counter clockwise (Photo below). This will take the pressure off pawl so
that it may be lifted. Lock pawl in up position by pushing slide bolt underneath the pawl.
13