Kifco E30x660 400,000 - Present Operator Manual - Manual (Page 21)

P/N 19302460 Copyright © May 2013 by Kifco ® Inc.
Start Up & Operation
Step-by Step Operation Continued
10. Verify that the coils of tube remaining
on the drum are both coiled and packed
tightly (photo). If they are not use the
hand crank and PTO input on the gear-
box to tighten them.
11. Attach supply hose. Verify there are no
kinks or twists in the supply hose.
12. Lower the anti reverse pawl prior to
engaging the drive system.
13. Engage the Gearbox
Turbine Drive: Engage the gear-
box by firmly pulling the disengage rod away from the gearbox and then turn the right
handle counter clockwise 1/8th of a turn.
Engine Drive: Push Left gearbox handle to engage.
14. Reset gearbox
gear selection by firmly pulling the disengage rod away from the gearbox and select fast or slow gear by
turning the right had gearbox handle. If the handle does not turn, rotate the gearbox pulley slightly.
Reset Handle (Attached
to Disengage Rod)
Engine Drive Turbine Drive
15