Katun Konica Minolta bizhub pro C5500-series - Manual

(A) Side Plate
(B) Spring / Bracket (F&R)
(C) Drive Gear
(D) Rear Plate
(E) Gear
(F) Ground Strap
(G) Front Plate
(H) OPC Drum
( I ) Bracket (F&R)
(J) Cleaning Blade
(K) Seal (F&R)
(L) Brush
(M) Lubricant Bar
(N) Bracket/Spring (F&R)
(O) Drum Unit Frame
Components in bold text
included in rebuild kit.
Rebuild Instructions
Konica Minolta bizhub pro C5500/C5501/C6500/C6501
Drum Unit DU-102C
Pre-Disassembly
NOTE: Do not remove any black screws at any point during this process.
Save all parts and hardware removed unless instructed to discard.
Disassembly
1. Remove side plate (A)
2. Remove F&R spring/bracket (B). Discard springs.
3. Remove drive gear (C).
4. Remove gear (E).
5. Remove ground strap (F)
6. Remove F&R plate (D&G)
7. Remove OPC Drum (H). Discard OPC Drum.
8. Remove F&R bracket (I)
9. Remove cleaning blade (J). Discard cleaning blade.
10. Remove F&R seal (K). Discard F&R seal.
11. Remove brush (L).
12. Remove lubricant bar (M) and F&R bracket/spring (N)
13. Remove F&R bracket/spring (N) from lubricant bar (M). Discard lubricant bar.
Clean drum unit frame (O) and all individual drum unit components that will be reused, as needed/required before assembly.
Assembly
Assemble drum unit in reverse order.
13-09-6651 © 2013 Katun Corporation
A
B
C
D
E
F
G
H
I
J
K
L
M
N
N
I
B
K
O