iCreation i-900 - Manual (Page 5)

5 44
Chapter 8: Additional Information
Troubleshooting
Symptom Solution
The phone doesn't works.
The phone works, but no
dial tone is heard.
Check the connection of the
switching power supply.
Check the connection of the
phone line cord.
The phone works perfectly,
but the ring volume is too
low.
Select another ring level.
Chapter 2: Bluetooth and Remote Control
Pairing with an iPhone
Connecting an iPhone
Disconnecting an iPhone
Removing a Paired iPhone
Remote Control for Music
18
18
20
21
22
Contents
Chapter 1: Getting Started
Features List
Phone Layout
Key Functions
Package Contents
Connecting
Charging the iPhone
Choosing the Dialing Mode
Setting Date & Time
Chapter 3: Basic Functions
Making a Call
Receiving a Call
One-touch Memory
Using the Speakerphone
Adjusting the Volume
Muting a Call
Last Number Redial
Flash Signal
Using a Pause
7
9
11
23
13
25
14
26
15
27
28
16
27
28
27
28
16
Disable Bluetooth in the
iPhone and then enable it
again, the disconnected
Bluetooth connection
between the base and the
iPhone cannot be
automatically resumed.
If there are interference
signals near or iPhone was
taken away from the base
(longer than 10 meters)
ever, the phone may lose
the connection with iPhone.
Due to differences in each
iPhone's software, so it is normal
for some iPhone that the
Bluetooth connection cannot be
automatically resumed. If in this
case, please establish the
Bluetooth connection manually
(See P18~ P19 "Connecting an
iPhone").
Switch off Bluetooth feature on
iPhone, then switch it on again.
/ Power off the base and then
power on.
The p hone doesn't work
properly with some special
services or if it is connected
to an exchange extension
(PABX).
Check the Flash time and set it
properly.