HYDAC HDA 5500 - Manual (Page 15)

14
display Setting
Setting
range Pre-
setting
device
Assign the analog output to the sensor
Assign sensor 1 to the analog output
Assign sensor 2 to the analog output
Sen1
Sen2 Sen1
HDA 5500 - 1 - X - XX - XXX
HDA 5500 - 2 - X - XX - XXX
HDA 5500 - 3 - X - XX - XXX
Assign sensor 3 to the analog output
Assign the difference value
(sensor 1 – sensor 2) to the analog
output
Sen3
Diff HDA 5500 - 1 - X - XX - XXX
Analog output signal
4..20mA output signal
MAMP/
VOLT MAMP For all devices
0..10V output signal
For all devices
Version number (Version)
actual software version (only to display)
For all devices
End of BASIC SETTINGS (End)
Leave the Basic Settings
Continue Basic Settings
YES/ NO NO
If the basic settings have been altered, ProG appears briefly when quitting the basic settings menu,
and then the selected display value is shown in the primary display.