HMC Electronics EDU2AE Kolver Programmable Power Control Unit for PLUTO Electric Torque Screwdrivers User Manual
Page 7
The program continues with the cycle sequence you have chosen, with the END signal lit at the end of the
sequence.
To progress to the third screen, push MENU again.
Third screen: SETUP PRINT
Available only with USB port option.
You can set date and hour.
PRINTED CYCLE: different description for each cycle, max 15 letters. It will be printed after each screw.
PRINTED DESCRIPTION: This is the description of max 50 letters on the main screen. It can be printed
only on request after specific input (pin 7) or at the beginning of each cycle (if this option has been allowed).
The TOP unit with USB port allows to save each cycle data.
It's just necessary to insert the key in the USB port, after a short bip, you can proceed.
In the key, a new folder will be created: EDU1AE_T. In it, there will be another folder called like the date
set in the unit (year-month-day). In this folder, every day you could save each cycle done in .txt file.
Example:
11/03/09 09:43 PR1 P15 S 20% 320RPM 01/03 OK_ ____ Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 02/03 OK_ ____ Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 02/03 NOK TMIN Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 03/03 OK_ END_ Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 00/03 NOK TMAX Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 01/03 OK_ ____ Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 02/03 OK_ ____ Program 1
11/03/09 09:43 PR1 P15 S 20% 320RPM 03/03 OK_ END_ Program 1
Date (day/month/year),
Hour (hh:mm)
Program number (PR1),
Model (in this example P15 means Pluto 15)
Joint (S = soft – H = hard)
Torque,
Speed (RPM)
Done/total Screws
Result (OK-NOK)
Error description and END (TMIN if the error is of the min time, TMAX if max time, END when cycle is
ended)
15 letters description.
N.B. All firmware versions support BOMS devices formatted in FAT12, FAT16 or FAT32 file systems only
where the sector size is 512 bytes. No other file systems or sector sizes are allowed.Furthermore, only
BOMS devices which support the SCSI or AT command sets are supported.On devices which implement
multiple LUNs, only the primary LUN (0) is supported. The VNC1L firmware can only access the primary
partition of a disk.
SCREWS
DATE
12/01/2000
PR 1
SETUP PRINT
TIME
01:15
PRINTED CYCLE
Program 1
PRINTED Made in Italy by Kolver s.r.l.
DESCRIPTION
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440