Heidolph REAX 2 - Manual (Page 16)

16
E
3.3. Inserting the Adapter
On one side of the adapter there is a square (C). First this square is inserted into the carrier (D),
see illustration. Then the knurled grip (E) is drawn and the pin (F) is placed in the receptacle (G).
Finally the knurled grip (E) is brought into its initial position.
OPERATION AND CONTROLS
Before connecting power cord with mains outlet, make sure that:
- your item is designed for your local voltage and frequency (data plate on item).
- master switch is set to "0" and all controls are in "min." position (turn CCW
completely); this way you avoid spilling fluids by too intense shaking action.
Carefully close your vessels and select appropriate shaking intensity (if vessels
remain open) to avoid splashes and spillage.
We recommend to start with a low shaking speed and gradually increase frequency
to avoid accidental shaking at high speed.
When handling hazardous fluids, make reference to applicable safety information.
C
D
E
F
G