beautypg.com

Set-up & operation, Aluminium flask inserts, Warning – Heidolph StarFish Water & Gas/Vacuum Distribution Manifolds User Manual

Page 10

background image

Set-Up & Operation

- Aluminium Flask Inserts

Fitting central support rod to base plate

There are a choice of two support rods; the 505-81050-00 650mm one piece rod and the

two piece 505-81060-00 650mm split rod. The spilt rod allows for shorter assemblies.

1. Screw the rod into the tapped central hole at the centre of the base plate
2. Using a suitably sized adjustable spanner, tighten the

captive nut attached to the rod to securely mount

the rod to the base assembly.

Aluminium inserts are designed to adapt the 250ml MonoBlock or PolyBlock to

accept 5ml, 10ml, 25ml, 50ml, 100ml, 150ml and 250ml round bottomed flasks.

1. Select appropriate insert. The insert size is engraved on the rim.
2. Place correct insert in the 250ml well, taking care to make sure it is fully located.
3. The aluminium inserts are designed in such a way that should the flask fall over it will

still remain supported at such an angle as to retain the typical working volume of that

flask. However we recommend the use of the 505-81020-00 Universal Telescopic

5-Way Clamp when using any round bottomed flasks.

4. When clamping smaller flasks the use of a glass joint adapter to extend

the neck of the flask will assist in clamping.

StarFish Multi-Experiment Work Station

5ml Aluminium Insert

10ml Aluminium Insert 25ml Aluminium Insert 50ml Aluminium Insert 100ml Aluminium Insert 150ml Aluminium Insert

505-80045-00

505-80044-00

505-80043-00

505-80042-00

505-80041-00

505-80040-00

Important Note

The aluminium inserts are designed in such a way that

should the flask fall over it will still remain supported at such

an angle as to retain the typical working volume of that flask.

Important, Important,

Important, Important,

Important, Important,

Important, Important,

Important, Important,

Important, Important,

Important, Important,

Warning

It is important to ensure that the rod

is tighten securely using a spanner,

otherwise the assembly may unscrew

and become unstable during use.

!

Page 9

Heidolph-StarFish Instructions 23-03-09:2nd draft 16-03-09 23/3/09 15:41 Page 10

This manual is related to the following products: