Reloading factory default settings, 5 reloading factory default settings – GeoDesy Gigabit 2400 Auto Tracking link series User Manual
Page 39
39
GeoDesy Kft.
Telefon: 06-1-481-2050
H-1116 Budapest, Kondorfa str. 6-8.
Fax.: 06-1-481-2049
E-mail: [email protected]
http://www.geodesy.hu
- All GigaNext-Series(1000 MB/s) will be limited after the 90
th
day, when the whole
bandwidth will be blocked, except the management system.
9.5 Reloading factory default settings
Should you need to reload the original factory settings follow the steps below.
1. turn ON the switch of Power Adapter
2. wait 3 seconds
3. then turn OFF the switch of the Power Adapter
4. above procedure 3 times.
5. plug turn ON the Power Adapter an leave it turned ON
After this the system resets the following information to the factory default.
- IP address
- Username
- Password
- Device name
- SNMP settings
- Alerts
- Auto MDI/MDIX
-
NPASD (if avialable):
if the reciver does not detect sufficient light power, then
in the head would switch off the network connection signal. Note: During this
perid the 100MB/s laser heads MGM will not be available.