GeoDesy Gigabit 2400 Auto Tracking link series - Manual (Page 13)

13
GeoDesy Kft. Telefon: 06-1-481-2050
H-1116 Budapest, Kondorfa str. 6-8. Fax.: 06-1-481-2049
E-mail: [email protected]
http://www.geodesy.hu
5 The mounting bracket
In the following chapter you will find detailed description of the bracket fastenings.
5.1 Mounting brackets for the AT Series
GeoDesy FSO provides the mounting bracket and all the necessary components
for AT series units. A simple fixing technique of this bracket can be seen on the
following figure, required tools are as follows:
- drilling machine
- 12 mm wrench
Installation steps:

Place the bracket on the wall

Mark the wall with a permanent marker

Use your 12mm wall drill to drill all of the holes into the wall

Clean the holes

Place the wall-plugs into the holes (please note that some times you need to
use hammer to put the wall-plugs into the hole, if you have to please be
careful not to break the wall-plug
)

Place the bracket to the wall an line it up to the holes

Put the screws into the wall-plug through the hole on the leg of the bracket
(please see the figure above)

Tighten up the screws