Gardman Easy Arch - Manual (Page 2)

1. Slot together tubes (A, B, C and D)
as shown to form one side of the arch.
Ensure screw holes for cross bars (E) line
up. (See inset) Note: Tubes A and C have
one male and one female end, B has two
female ends.
2. Repeat step 1 for the other side.
3. Fit one end of all cross bars (E) to one
side of the arch as shown
(See inset) using assembly screws (F).
4. Fit other side of arch to remaining
ends of cross bars (E).
5. Place assembled arch in desired
location. If the ground is soft the
arch can be pushed into the ground.
Where the ground is particularly hard
fitting can be aided by either watering
the ground or pushing a suitable rod or
spike in first. A depth of approximately
0.40m (1' 4") is recommended.
Helpful hints:
You may find it easier to assemble your
arch horizontally on its side and then
carefully stand it upright to install.
If the screw holes on the poles are
covered with a thin layer of the
protective coating, carefully remove
this by pushing a small nail through
the coating.
Assembly
C
B
D
F
A
E
1.4m
(4'7")
0.37m
(1'2")
All sizes approx.
WIDTH
DEPTH
TO
T
AL HEIGHT BEFORE FITTIN
G:
2.4m
(7
'10
")
BELOW GROUND
0.40m
(1'4")
2m
(6'6")
HEIGHT ABOVE
GROUND