beautypg.com

Burner & pilot flame check, When used as a heating appliance heat output – New Buck Corporation CR8T User Manual

Page 17

background image

BURNER & PILOT FLAME CHECK

A periodic check of the flames should be made. The flame should always be present when
the gas logs are in operation.

Flames: The flame should extend about 3” to 4” above the rear log for natural gas and
about 6” for propane (LP) gas.

Figure 4

WHEN USED AS A HEATING APPLIANCE

HEAT OUTPUT

The heat output into the room can be controlled by the position of the flue damper, when
used as “Vented Gas Logs”. See Section VI-Vented Models.

The gas logs may be used as non-vented gas logs only where permitted by local state and
city codes. If non-vented gas logs are not permitted, then the fireplace vent area required by
local codes must be met. The installation must conform with local codes or, in the ab-
sence of local codes, with the National Fuel Gas, ANSI Z223.1/NFPA 54. Check your
state or local codes.

CR8T LOGS & BASE

PILOT

NATURAL

PROPANE

13