New Buck Corporation CR8T - Manual (Page 16)

THERMOSTAT CONTROL OPERATION
The thermostat control used on this heater differs from standard thermostats. Standard
thermostats simply turn the burner on and off. The thermostat used on this heater senses the
room temperature and adjusts the amount of gas flow to the burner. This will increase
or decrease the flame height. At times, the room may exceed the set temperature, which will
cause the burner to shut off. When room temperature drops below the thermostat setting,
the burner will cycle itself on again. The flame control knob can be set to any level between
2 and 7.
NOTE: The thermostat sensing bulb measures the temperature of air near the heater cabinet.
This may not always agree with room temperature ( depending on housing construction,
installation location , room size, open air temperature,etc.). Frequent use of your heater will
allow you to determine your personal comfort levels.
MANUAL LIGHTING PROCEDURE
1. If the pilot cannot be ignited with the ignitor on the control valve, it can be manually lit
with the use of a paper match and a lighter rod.
2. Place the match in the holder and light. With other hand, depress the control knob
counterclockwise to PILOT.
3. Use rod to light match and ignite pilot. The pilot is located behind the burner tub and in
front of the rear log. Fully open the manual shut-off valve.
4. Continue to hold the control knob for an additional (1) one minute to ensure the pilot
is completely on.
• If the knob does not pop up when released, stop and immediately call your service tech-
nician or gas supplier.
• “If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and
call your service technician or gas supplier.”
5. Turn control knob counterclockwise to “ON” position.
“Set thermostat (flame control) to desired setting. Turn clockwise for “LOW”
and counterclockwise for “HIGH”.
6. Close the access panel door.
7. “Turn on all electric power to the appliance.”
12