Braun NUVL603C - Manual (Page 12)

Page 10
Inboard Locator
Linkage Rod
I
Inboard Locator Linkage Rod Adjustment
Do not adjust the
inboard locator
linkage rod un-
less extra usable
platform length
is needed. See
Photo H. If the an-
gle of the inboard
locator (when in
Linkage rod adjustment affects angle
of inboard locator (vertical position).
CAUTION
Improper inboard
locator linkage rod
adjustment may
result in lift damage.
the vertical position) restricts the usable platform
length for the wheelchair passenger, adjustment
of the linkage rod will change the angle.
Adjust the inboard locator as detailed in the
previous procedures. Then, adjust the linkage
rod as detailed (only if necessary). If the link-
age rod is adjusted too long or too short, it will
exceed the travel of the slider block resulting in
damage to the cam follower bearing, the cam
and/or other components.
1. Position the lift platform below stow level
using the manual operation system. Do
not operate the lift with the electric pump
during adjustment procedures.
2. Loosen the jam nuts at each end. Adjust
rod length as needed. Minimize adjust-
ment. Carefully check the inboard locator
angle and operation using the manual
operation system. Ensure the rod has not
been over adjusted resulting in pressure on
components (damage will result). Tighten
the linkage rod jam nuts.
H
Floor Level and Inboard Locator Adjustments