Equity by La Crosse 40222B Insta-Set Analog Clock - Manual (Page 2)

Note: To change the Time zone, DST, or time, the mode switch (8) must be in SET
position. Remove the “AA” batteries, and then follow the setting steps above.
DAYLIGHT SAVINGS TIME
If you live in an area that does observe DST, place the DST switch into the ON
position. The clock will now adjust automatically each spring and fall to correct for
the 1-hour time change.
If you live in an area that does not observe DST, such as Arizona, Hawaii, or parts of
Indiana, place the switch into the OFF position to deactivate the DST function.
REPLACING 3V LITHIUM BATTERY
The Auto-set time memory is maintained by a lithium button cell battery, model CR2032.
The expected life of this battery is about 8 years. Be sure that the 2 “AA” batteries
in the clock are fresh. The MODE switch (8) must be in the RUN position when replacing
this button cell battery. This battery is located in the small round battery
compartment on the rear of the clock secured by a screw. Open the battery compartment
(3) with a screw driver and replace the CR2032 lithium battery observing the polarity.
Then close the compartment securing with the screw.
SETTING THE CORRECT DATA INFORMATION IN THE LCD DISPLAY
1) Manually turn the clock hands to 12:00
2) Be sure a fresh Lithium button cell battery is in place, model CR2032
3) Slide the time zone switch (2) to the desired time zone position
4) Choose DST on or off, by sliding the DST switch to ON or OFF position
5) Slide the mode switch (8) to SET position, a SETUP icon will be flashing on the
display. The HOUR digit will be also flashing. Press (+) key (6) or (-) key (7) to
adjust to the correct hours. Note the “PM” indicator on the LCD display.
6) Press MODE key (5) once, the minute digit will be flashing. Press (+) key (6) or (-
) key (7) to adjust to the correct minutes.
7) Press MODE key (5) again, to set month, day, year, similarly.
8) Insert two fresh “AA" alkaline batteries into battery compartment (1), according to
the polarity shown.
9) You can slide the switch (8) to SEC position, press (+) key (6) to have the clock’s
second hand move to 12:00 position.
10) Slide the switch (8) to RUN position, the clock’s hands will move quickly, and
automatically synchronize the new time data in the LCD display.
REPLACING THE “AA” BATTERIES
For best performance, replace the “AA” batteries annually to maintain accuracy. With
the MODE switch in the RUN position, remove the old “AA” batteries. Make sure the
hands are in the 12:00 position. If not so, manually turn the hands to 12:00. Insert 2
fresh “AA” alkaline batteries into the battery compartment (1) according to the
polarity shown. The clock will automatically move to the correct time displayed in the
LCD display. Alkaline batteries are recommended. Carbon zinc and rechargeable (nickel
cadmium) batteries are not recommended. Please help in preservation of the environment
and return used batteries to an authorized depot.
Two Year Warranty (U.S.A.)
Equity products are warranted for two years from the date of consumer purchase against defects in material and