Elkhart Brass UBEC 2 to control an E4F or E6F actuated valve - Manual (Page 2)

Programming; see section Xll, pages 56 -58 of the Unibody valve instruction manual.
You will need to program the unit;
 To be a remote.
 To reverse polarity (only if an E4F is used on an EB_J Jamesbury butterfly
valve.)
 To change the pressure display units (if they want something other than PSI).
2) After the UBEC2 has been programmed cycle the power to it and then transfer the
program from the UBEC2 controller to the E4F or E6F actuator using the instructions on
page 62 of the manual (see transfer code 4110) and then cycle power to the actuator.
3) After step 2 is complete auto calibrate the valve per the instructions in step 2 on page
63 of the manual.
Figure 1
Figure 2