Elkhart Brass SPIT-FIRE 8394053 Monitor - Manual (Page 8)

8
OCP (LOCAL OR REMOTE) LAYOUT
• Before going through the setup instructions check
that the connections between all boxes have been
completed.
• No data can be changed in display 1 and 2.
• Displays 3 thru 6 are for setting Monitor Park
position and oscillation.
• Data can be changed at the cursor location by using
the [UP] key to increase the value or [DOWN] key to
decrease the value.
• To enter the data and move to the next screen press
the [OK] key. The data that is displayed will be
entered.
• To cancel any data changes press the [ESC] key.
Press [ESC] key again and go back to the first screen.
• Refer to the Operator Control Panel (OCP) Setup
Instructions for more detailed information on all
displays.
Manual Controls and Indicator
Lights for Monitor #1
MicroLogix 1400 for
Monitor #1
Terminal Blocks for
Monitor #1
MicroLogix 1400 for
Monitor #2
Terminal Blocks for
Monitor #2 Manual Controls and Indicator
Lights for Monitor #2
ESC
OK
[Up] Key
Increase Value
[Down] Key
Decrease Value
[Left] Key
Move Flashing
Cursor Left
[Right] Key
Move Flashing
Cursor Right
[OK] Key
Enter Value
[Esc] Key
Cancel Change
Keypad for MicroLogix 1400