Elkhart Brass Cobra EXM Light Kit - Manual (Page 3)

3
3. Remove the 10-24 button head screw and clamp loop from the inside of the control module housing.
Store the screw and clamp loop in a place where they will not be lost or damaged; they will be used
later.
4. Mount the light bracket to the now empty holes of the control module housing using the two (2) new
sets of supplied 10-24 screws and hex nuts as shown. Apply blue Loctite #242 or equivalent to the
screw threads. Use the supplied clamp loop (new with kit) to hold the harness going to the light in
place as shown.
5. Remove the wedgelock from the gray 12-pin plug on the monitor harness with a small slotted
screwdriver as shown. Store the wedgelock in a place where it will not be lost or damaged; it will be
used later.