Elkhart Brass SFL-GN-125 - Manual (Page 6)

the nozzle in the flush position. The water supply
should be secured and the nozzle disconnected from
the hose so the debris can be removed from the inlet
end of the nozzle.
B. Uneven stream pattern or gaps in stream pattern.
Pattern affected in all stream positions and affected
area rotates with the turning of Nozzle Tip.
The most likely cause of this problem is damage to the
Nozzle Tip. Inspect the metal teeth and the inside
diameter of the Nozzle Tip, on the discharge end, for
damage. If damaged the nozzle should be replaced,
C. Leakage at the connection of the nozzle inlet to the
hose coupling.
This may be caused by a worn gasket in the Free
Swivel Base of the nozzle. Replace the gasket and
retest the connection. If leakage continues look for
damage to the threads or surfaces that contact the
gasket. Replace the nozzle if the threads or gasket
surface are damaged. Replace or repair the hose
coupling if the threads or gasket surface are damaged.
6