Elkhart Brass TFLX-20 - Manual (Page 7)

7
IV. F
LEX
A
TTACK
®
M
AINTENANCE
The following maintenance procedures should be followed in order to reduce to possibility of field
difficulty or failure.
A. Inspections
Weekly visual inspections and monthly operational checks will promote proper nozzle function.
These inspections may be done daily in busy companies. All nozzles should be flow tested before
entering any hazardous environment to ensure equipment is operating properly.
B. Maintenance After Use
The nozzle should be flushed thoroughly after every use. This can be done by flowing a clean
water source through the nozzle. The internal passageway of the nozzle should also be visually
inspected for possible damage caused by foreign objects carried by the water through the nozzle.
C. Storage
The Flex Attack
®
nozzle should always be stored with the discharge selector in the Dry
CAF/largest diameter setting. This will ensure that no water is trapped in the nozzle during
storage.
Important:
If there is a question regarding any necessary repair or damage issue, contact Elkhart Brass for
assistance.
Phone #: 800-346-0250
Email: [email protected]