B&B Electronics PCMCIA 232PCC2 - Manual (Page 5)

4 Documentation Number 232PCC23799 Manual
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353-91-792444 – Fax +353-91-792445
232PCC2 Client Driver for DOS
In order to use the 232PCC2 Client Driver, the system must be
configured with Card and Socket Services software.
IMPORTANT:
Some versions of Card and Socket Services dated before 1993
do not support general purpose I/O cards. If after careful installation
of the Client Driver the 232PCC2 does not configure or operate
properly, an updated version of Card and Socket Services may be
required.
Client Driver Installation
The following procedure is used to install the 232PCC2 Client Driver:
• Copy the file DSP100CL.SYS from the 232PCC2
distribution diskette onto the system's hard drive.
• Using an ASCII text editor, open the system's
CONFIG.SYS file located in the root directory of the
boot drive.
• Locate the line(s) in the CONFIG.SYS file where the
Card and Socket Services software is installed.
• AFTER the line(s) installing the Card and Socket
Services software, add the following line to the
CONFIG.SYS
file:
DEVICE = drive:\path\DSP100CL.SYS options
where options are the 232PCC2 Client Driver command
line options discussed on the following pages.
• Save the CONFIG.SYS file and exit the text editor.
• Insert the 232PCC2 into one of the system's PCMCIA
slots.
NOTE: Since the 232PCC2 Client Driver supports "Hot
Swapping", it is not necessary to have the 232PCC2
installed when booting the system. By inserting the card
before booting, however, the Client Driver will report the
adapter configuration during the boot process thereby
verifying the changes made to the CONFIG.SYS.