Despatch LAC2-12-6 - Manual (Page 21)

LAC Series Oven Owner’s Manual A SSEMBLY & S ETUP
Version 106 21
Copyright © 2011 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
2. Do not expose the oven to excessive external vibration
3. Do not remove electrical cabinet covers
4. Where excessive particulate matter is present, such as on a construction site or coal
processing, Despatch recommends periodic (usually monthly) cleaning of all
electrical compartments.
5. Ensure the power supply meets Despatch specifications. If the facility power supply
is not stable, Despatch recommends a line conditioner.
4.2.2. Set-up Procedure
1. Place oven on bench top or optional cabinet base.
a. Ensure a minimum of two (2) inches (5.1 cm) clearance in the rear of oven to
provide proper ventilation. The oven may be placed next to another cabinet, or
next to another oven, with three (3) inch (7.6 cm) clearance (the doors will still
open).
b. Ensure oven is level and plumb for proper heat distribution and operation of all
mechanical components.
2. Identify correct power source indicated on the specification nameplate.
3. Plug or hardwire oven directly to the electric supply.
Warning!
All grounding and safety equipment must be in compliance with
applicable codes, ordinances and accepted safe practices.
Warning!
Do not use the oven in wet, corrosive or explosive atmospheres
unless this oven is specifically designed for a special
atmosphere.