dB TECHNOLOGIES DVA NETWORK 1.2 Device Plugins Manual - Manual (Page 4)

3/17
Rev 1.0
Each panel contains:

Vu-meter bar on the left (green): channel amplifier output level in dBfs (decibel full. scale, 0dBfs =
maximum power delivered) ;

Vu-meter bar on the right (red): channel limiter compression level in dB;

amplifier temperature: indicated in °C

Status indicator: green = channel is ok; Red = malfunction is detected;

MUTE: single audio way mute
Preset panel: Select a different audio preset (see Speaker User manual).
Group panel: Assign the speaker to a Group Equalizer. When assigned, equalization delay or volume can
be modified in the Group Eq window.
Thermal Limiter: becomes yellow when amplifier module starts reducing Audio volume to prevent
overheating.
FW Rev: Show revision of currently loaded Firmware.
Temp: indicates PSU temperature in °C.
Standby: enter in standby mode to reduce internal temperature and energy consumption in long
inactivity conditions. Button is usually green and becomes red in "stand-by" condition.
Anyway, DVA Network communication remains active and speaker can be reactivated at any time by
pressing the key again.
ATTENTION!!
If activated, standby button will switch PSU module off and will deactivat audio on all 3
output channels.
Factory Default: Allows to reset all settings made via DVA Network software and to restore factory
configuration settings.
ATTENTION
Speaker must be assigned to a group in order to modify the audio equalization.

