dB TECHNOLOGIES DVA Series - Manual (Page 12)

DVA T8
Top Performance Combined With Total Control
Handling, Stacking and Flying Cabinets
The DVA T8 comes with built-in rigging hardware. The splay between
enclosures may be adjusted in incrementally from 0° to 15°. The DRK-10 harness
holds up to 16 flown T4 units. At just 14.2 kg, the DVA T8 is exceptionally light so
an array with six elements weighs less than 100 kg. This is an advantage greatly
appreciated by everyone who handles and transports the array.
A single person can rig up and fly the system, even from trusses and towers rated
to handle lighter loads.
Very light point load
Precise alignment
DRK-10 harness flies up to 16 units
Compatible with DVA T12 units
DVA T8 and DVA T12 series housings are acoustically
and mechanically compatible.
This means DVA T12 units may be flown right above
a T8 array for use as far-fills.
Compatible DVA T12s may serve as far-fill extensions
DSA 4 pole mount adapter
The DSA 4 pole mount adapter holds up to 3 DVA T8 modules
on one pole. A set screw adjusts the tilt angle, smoothly and
precisely. Compact PA systems can be configured for smaller
applications simply by adding
S1518N subwoofers to the setup.
Ground stacks with DVA subwoofers
The DRK-10 harness can also serve to stack cabinets on the ground when rigging
points are unavailable or the ceiling is too low.
Active Line Array Module
15