DATOptic U3eS_RM - Manual (Page 2)

Introduction:
U3eS_RM is a eSATA & USB 3.0 to Penta SATA II Drives RAID Controller
Board. It is designed to provide SATA ports expansion, data protection and
performance aggregation in various applications.
U3eS_RM uses market-proven Multi-port Serial ATA
PHY technology (Port Multiplier Ware) and a proprietary storage processor to
provide very highly efficient SATA RAID operations. With an easy
configuration scheme, the device can function as a pure port multiplier which
provides SATA port expansion just like a SATA Hub. Or connected HDD can
configured as a RAID, with boots the performance and data protector which
automatically backs up data to prevent data loss from hard drive damage, but
WITHOUT the hassle of drivers and software installation.
Addition to the benefits of performance boost and data protection. U3eS_RM
has am embedded storage processor chip, which completely frees up the
main CPU resource.
Making it an ideal to control and manage a must have protect, reliable mass
data storage.
Feature:
• Connect up to five SATA hard drives or optical drives to any system via
any eSATA port or USB 3.0 / 2.0 port
• Support SATA I / II / III hard drive
• RAID configuration in two ways
• Onboard dip switches
• RAID GUI utility Mac, Window, Linux
• Integrated storage processor to maximize performance
• Compatible with SSD, SATA I, II, III. ODD
• RAID volume can be used as a boot drive or as additional storage
• Multiple units can be daisy chained
• Supports RAID0/1/3/5/10/SPAN (BIG)/CLONE/JBOD
• Supports JBOD mode via eSATA* or USB connection
• Email notification capable in MAC, Windows and Linux
• Supports hot swap when attached to USB port or eSATA port that
supports this feature.
• Drive activity LED and Error LED for Host and 5 SATA devices
• Driver-less RAID solution to ANY OS support SATA eSATA and or
USB2.0/USB3.0
Overview
– P0~P4: SATA ports, connect to HDD or ODD
– JP1: Power connector
– SW1: Mode Selection dip switch. Refer to set up figure in Dip Switch
Section
– SW2: Activate/Set mode setting
– JP2: LED power indicator
– J1: eSATA, SATA0-4 ports active/busy LED
– J3: eSATA, SATA0-4 ports error LED
– USB3.0 Host connection
– eSATA: eSATA Host connection
Active and Error LED Indication
Description Active LED Error LED
Device Unplugged OFF OFF
Device Plugged ON OFF
Device Plugged (Active) Flash (ON) OFF
Device Error OFF ON
Device Rebuild Flash (ON) Blink