Dascom LA550W Quick Start Guide - Manual (Page 26)

Settings Quick start guide
24
Setting the first printing line
(TOF) You can use the TOF function for setting the position of the first printing line for
each paper source and each menu individually.
Before using the TOF function (if fanfold paper is used), you first have to set the
tear position (see above).
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the TOF (3) key.
The paper is fed to the position where the bottom edge of the first printing line is
aligned with the tear edge of the printer. The factory setting for the first printing
position (TOF) is 12/72". This is equivalent to the second line from the top.
Press the < (2) or > (3) key to move the first printing line to the desired position.
You can set values from 0 to 220/72" for fanfold paper or for single sheets.
12/72" corresponds to a printing line.
Adjust Paprpath
Menu Char Online
Setup
2 1 3 4
TOF
Head Tear Online
Setup
2 1 3 4
FormAdj= 12/72"*
Set < > Exit
Online
Setup
2 1 3 4
First printing line, default First printing line, default
Readjusted first printing line Readjusted first printing line
12/72"
0–220/72"
Quick Start-en.book Seite 24 Dienstag, 22. Juni 2004 1:33 13