Dascom LA550W Quick Start Guide - Manual (Page 10)

Installation Quick start guide
8
Checking the printer
voltage Make sure that the device has been set to the correct voltage (e.g. 230 V in Europe,
120 V in the USA). To do this, check the type plate above the power inlet at the
back of the printer.
Never switch on the printer if the voltage setting is incorrect, since this may result
in severe damage.
You can set the printer to the correct mains voltage yourself.
To do this, cautiously place the printer on its back side.
Use a suitable object (e.g. a screwdriver, but never a pencil)
to set the slide switch on the left at the bottom of the printer
to the correct voltage.
STOP
pull to open
pull to open
120 V
Front side of printer
Back side of printer
230 V
Quick Start-en.book Seite 8 Dienstag, 22. Juni 2004 1:33 13